Case Study – Solar Energy Fed Cellular Communication Base Station,

Can a Bess be used with a battery energy storage system?

Measurements of battery energy storage system in conjunction with the PV system. Even though a few additions have to be made, the standard IEC 61850 is suited for use with a BESS. Since they restrict neither operation nor communication with the battery, these modifications can be implemented in compliance with the standard.

When can large quantities of electricity be stored and retrieved?

Large quantities of generated electricity can be stored and retrieved anytime too little power is produced . Such a scenario can only be implemented when data is exchanged properly among a BESS, PV system and control system .

What are the components of a battery system?

The system consists of three components: a control center, a PV system and a BESS. Depending on the PV system's output and supply forecast, the control center prompts the change of the incoming and charging power at the battery by transmitting the SetData and SetValues services.

How does the control center communicate with the PV system?

The control center communicates with the PV system by a Modbus protocol and with the BESS by IEC 61850. The IEC 61850 data structures provided by the BESS were created beforehand by a configuration file. Fig. 5 presents a schematic of this structure. Fig. 5. use case “meeting the supply forecast”. 5.1. Constraints on implementation

What are the logical nodes of the battery system zbat & zbtc?

The logical nodes of the battery system ZBAT and the battery charger ZBTC are responsible for battery data. The node ZBAT contains general information on the battery, including battery type, capacity and charging (power injection). They can also be used to perform logical node tests and to switch the system on and off.

Do cellular network operators prioritize energy-efficient solutions for base stations?

Recognizing this, Mobile Network Operators are actively prioritizing EE for both network maintenance and environmental stewardship in future cellular networks. The paper aims to provide an outline of energy-efficient solutions for base stations of wireless cellular networks.

How to make base station (BS) green and energy efficient?

This paper aims to consolidate the work carried out in making base station (BS) green and energy efficient by integrating renewable energy sources (RES). Clean and green technologies are mandatory for reduction of carbon footprint in future cellular networks.

What is base station energy consumption index (ECI)?

Brief description about components of the base station Energy Consumption Index (ECI)—It represents the efficiency of BS power utilization. The lower value of ECI means greater EE as mentioned in Eq. 6 below. Its unit is J/bit.

What is intelligent energy management scheme?

An intelligent energy management scheme is shown which reduces coverage when battery back-up drops below a certain threshold. The algorithm selects one of pre-determined traffic patterns as per weather forecast data and controls the charging of the batteries as well. 3.5. Summary of resource management in singular configuration

How can multi-cell cooperation optimize BS' energy consumption?

Scheduling of cell sizes, like dividing a macro cell into micro cells, or shutting down micro cells by extending coverage (cell zooming) with macro cell when traffic is low, is another way of multi-cell cooperation to optimize BS' energy usage ( Le et al., 2011 ).

Does small cell deployment increase energy-delay?

Small cell deployment normally results in greater EE, but as the density of small cells increases, this gain saturates. Thus, an optimized combination of sleeping parameters and service rate could be obtained to generate the optimal values of the energy-delay trade-off.